LitaElek LED Strip Connector 4 Pin RGB 5050 LED Strip Corner Connector LED Ribbon Solderless L Shape Connector Right Angle Adapter for 10mm Wide SMD 5

These corner connectors are compatible with both non-waterproof and waterproof SMD 5050 RGB LED strips that are 10mm in width and have 4 copper contacts at every cutting line. The wireless and solderless design ensures seamless layout when you need to spread your LED strips around corners. You can install them on your LED strips directly without using any tools. Precautions: When you cut your LED strip into 2 LED strips, you should cut very carefully along the cutting line, to make sure the area of the copper contacts on the 2 LED strips are the same. (not a bigger area of copper contacts on one LED strip, and a smaller area of copper contacts on the other LED strip.). If the area of the copper contacts on the LED strip is too small, the 4 electrical conductors in the connectors can not totally touch the 4 copper contacts on the LED strip, and there will be poor electrical conductivity. As a result, you may get 2 different colors or even get no colors at all. Installation Instructions: 1. Ensure your LED strip is 10mm wide 4 pin RGB 5050 LED strip and has 4 copper contacts (+, G, B, R). 2. Carefully cut your LED strip along the cutting line. 3. Open the cap of the connector. 4. If you use a non-waterproof LED strip, please insert the LED strip into the connector. Make sure the 4 copper contacts on the LED strip are under the 4 electrical conductors in the connector. Make sure to match the + side of the LED strip to the + side of the connector; If you use a waterproof LED strip, please first remove the silicon around the cutting line, then insert the LED strip into the connector. Make sure the 4 copper contacts on the LED strip are under the 4 electrical conductors in the connector. Make sure to match the + side of the LED strip to the + side of the connector. 5. Close the cap. Package includes: 10x L-shape 4 pin connectors