These connectors are compatible with both non-waterproof and waterproof SMD 5050 RGB LED strips that are 10mm in width and have 4 copper contacts at every cutting line.
You can install them on your RGB 5050 LED strips without using any tools.
Precautions:
When you cut your LED strip into 2 LED strips, you should cut very carefully along the cutting line, to make sure the area of the copper contacts on the 2 LED strips are the same. (not a bigger area of copper contacts on one LED strip, and a smaller area of copper contacts on the other LED strip.).
Installation Instructions:
1. Ensure your LED strip is 10mm wide 4 pin RGB 5050 LED strip and has 4 copper contacts (+, G, B, R).
2. Carefully cut your LED strip along the cutting line.
3. Open the cap of the connector.
4. If you use a
non-waterproof LED strip, please insert the LED strip into the connector. Make sure the 4 copper contacts on the LED strip are under the 4 electrical conductors in the connector. Make sure to match the + side of the LED strip to the + side of the connector;
If you use a
waterproof LED strip, please first remove the silicon around the cutting line, then insert the LED strip into the connector. Make sure the 4 copper contacts on the LED strip are under the 4 electrical conductors in the connector. Make sure to match the + side of the LED strip to the + side of the connector.
5. Close the cap.
Package includes:
10x Solderless 4 pin LED connector cable for RGB 5050 LED strips
LitaElek 10pcs LED Strip Connector RGB 5050 LED Tape Connector Solderless LED Connector 4 Pin LED Ribbon Connector Cable LED Rope Jumper for 10mm wide SMD 5050 RGB LED Strip Light 17cm/6.7in Long
Was:
$97.78
Now:
$48.89
- SKU:
- YTH37197
- UPC:
- 737590296147
- Condition:
- New
- Availability:
- Free Shipping from the USA. Estimated 2-4 days delivery.