Legrand - Pass and Seymour T600LLAV Lighted Toggle Dimmer Switch 600-watt Single Pole Dimmer Easy Install Light Almond

Specifications: Tough, impact-resistant thermoplastic housing. Power-failure memory. Superior heat management: no time wasting break off tabs. Exclusive, screw-pressure-plate back wire terminals eliminates wire nuts Steps for Installation: 1. Disconnect power to circuit by removing fuse or turn circuit breakers OFF before installing. 2. Remove wall plate and switch mounting screws, pull existing switch from wall box. 3. Disconnect existing switch from circuit. 3-way installation: Identify the “Common” wire (wire connected to the terminal marked common or odd colored terminal). For “new” installation identify wire connected to power source or to the load. 4. Connect dimmer as shown in the installation diagram using #12 or #14 AWG stranded or solid copper conductors. Strip wire using gauge on back of device. 5. Install dimmer in wall box, with word ‘TOP’ on the strap right side up, using mounting screws provided. 6. Attach wall plate, then restore power to circuit. NOTE: It is necessary to remove knob on Short Slide version before attaching wall plate.