L298N Driver Module, Dual H-Bridge Robot Stepper Motor Control and Drives Module for Stepper Motor Smart Car Robot Power Control

Product features: This motor driver has strong driving ability, low heat, strong anti-jamming ability. H-bridge two-channel type driver, drive voltage is 5V to 35V, drive current is 2A. For better heat dissipation is a large heat sink on board. Practical to use, with screw terminals for easy wiring. It is usually used to drive stepper motors on smart cars or robots. Specifications: Working mode: H-bridge drive (dual-channel) Main control chip: L298N Logic voltage: 5V Drive voltage: 5V-35V Logic current: 0mA-36mA Drive current: 2A (MAX single-bridge) Storage temperature: -20 to + 135 Max. Power: 25W Size: 4.5 * 4.5 * 2.8cm / 1.7 * 1.7 * 1.1in Weight: 27g (approx.) Annotation: 1. When the operating voltage is 7V-12V, a 5V on-board logic voltage can be used as the power supply. If you use 5V as a power supply on board, do not input voltage to the + 5V terminal, but this may result in an external 5V voltage. (This is a regular application) 2. If the operating voltage is higher than 12 V and less than or equal to 24 V, for example to operate a motor with a rated voltage of 18 V, you must first pull out the jumper of the 5 V output enable. Then connect 5V to the 5V output is external. 5V enable is a control with a 5V level; If the input is valid and the motor drive module power supply is normal, the motor driver module will output power. Otherwise, even if the power supply is normal, there is no power on the motor. Package contents: 1 x motor driver