Kuman Raspberry Pi Holder Breadboard Kit, 7 in 1 RAB Holder kit for Arduino Uno R3, Mega 2560 & Raspberry Pi 3 Model B, 2 Model B,1 Model B+ RPI Zero and Zero W

Introduction: This RAB Holder Kit provides you all the necessary components for a simple experiment, including a RPi GPIO Breakout Expansion Board, a Ribbon Cable, Raspberry PI GPIO 40 pin Table Card for wiringPi and BCM codes,a breadboard, quite a lot of jumper wires, an RAB holder, nine LEDs, and ten 1K current-limiting resistors, thus you can start the experiment right away.> The Kit offer a GPIO hole corresponding table card for you, AS NO ANY PIN MARKED on the Rasberrry Pi motherboard interface, It is not convenient for every experiment to check the Pin corresponding ,Simple Use: Only need to cut along the dotted line down and directly set on the raspberry Pi motherboard , you can intuitive see each pin corresponding GPIO function.> With this kit, you can fix your Arduino board, Raspberry Pi 3B/ 2B/ 1B+/ Zero/ Zero W, and breadboard on the RAB Holder, free of careless short circuits on a metal desk or caused by some metal parts underneath. RPi GPIO Breakout Expansion Board and Ribbon Cable are for the Raspberry Pi 3B/ 2B/ 1B+/ Zero/ Zero W. What's more, it also comes with 65pcs jumper wires with different length in various colors, therefore, you can just plug them into the control board and breadboard to build circuits, no bothering about complicated soldering.>> Specifications: RAB Holder Size: 202.7 x 136.5 mm (7.98 x 5.37 inch) Package Included: 1 x RAB Holder 1 x GPIO 40P Breakout Board For Raspberry Pi 3B/ 2B/ 1B+/ Zero/ Zero W 1 x 20cm FC40 40pin Flat Rainbow Ribbon Cable 1 x GPIO 40 pin Table Card for all Raspberry PI versions 1 x 830-Point Breadboard 65 x Jumper Wire 10 x 1k? Resistor 9 x LED (3 red, 3 yellow, and 3 green) 1 x Screwdriver 4 x M3*6 screws ,4 x PWM2*6 screw, 4 x PWM2*4 screws, 3 x Screw copper nuts