Vacuum Suction Cup Hook Holder
?Product Materials: ABS+PVC ?Recommended Maximum Load: 11lb ?The Diameter Of Center Post: 3.15"(80mm). ?The Diameter Of Suction Cup Base: 3.39"(86mm) ?PackageWeight: 0.48 lbs (0.22KG) ?Installation Method: Suction ?Packaged Included: Vacuum Suction Cup Hook Holder *4
?Installation Steps:
1.Please clean and dry your wall before use,make sure the wall is flat and smooth. 2. Remove the plastic protective film.the PVC base, Press as tight as possible to squeeze the air inside, keep the suction cup vacuum. 3. After extruding the internal air, cover the suction cup cover. 4. One hand hold the center of the suction cup, the other hand tighten the hook in a clockwise manner until fully tight to ensure successful installation.
?How To Remove:
Twist the hook in an Anti-clockwise manner until can not rotate. Pull up on the release tab to release the suction and remove. Wash PVC base bottom with water,reuse it after drying.
?Matters Needing Attention:
1. Overload-maximum weight 5KG (11lbs). 2. Suction cup work by the vacuum but the sticky PVC base which can help you place the suction cups easily. 3. It would not hold unless the surface is sealed to a point of stopping all air leakage. Please check again whether the wall is suitable for installation.
