Jumper-XYZ R1 R8 R1F Receiver 16CH Sbus RX Compatible Frsky D16 Mode Radio Remote Controller (R1F Receiver)

R8 receiver : Number of channels: 8ch (PWM) / 16ch (SBUS) RSSI (Signal Strength Indication) output: PWM Operating voltage range: 4.0~8.4V Operating current range: 100mA@5V Effective distance: full distance (>2.0km) Compatibility:D8 mode, D16 mode With RSSI output: analog voltage output (03.3V)    Features: - More channels: 1-8 channels from traditional channel output, 1-16 channels from SBUS port - RSSI output: analog voltage output (03.3V) - Two-way full duplex transmission (Telemetry) - LED color :The green light is always on: the signal is good; the green light is blinking: the signal is bad; the red light is always on: the signal is lost   Pair code method: 1. Press the bind button on the receiver, red/green LED solid on 2. On radio side, select Frsky D16 protocol (T12/T16: Multi Frsky D16); 3.When Red LED is flashing, binding succeeded. 4. After binding, withdraw the binding mode and power up the receiver again.  Green Led turns solid on.   R1 receiver :  Number of channels: 16ch (SBUS) RSSI (Signal Strength Indication) output: 0-3.3v Data return: S.port Operating voltage range: 4.0~6V Operating current range: 80mA@5V Effective distance: full distance (>1.5km) Compatibility: FrSky Taranis D16 Mode Volume: 20*15*4mm (without antenna) Bind mode: Press and hold the receiver's frequency button, turn on the power, the red and green lights are always on, and the receiver enters the frequency mode. The remote control turns on the frequency. The receiver is successfully paired and the green light flashes slowly. The remote control exits the frequency, the receiver is powered back on, and the green light is on. When the receiver loses its signal, the red light is on.