JJC Radio Wireless Remote Control for Canon EOS 6D,7D,5D Mark IV III II,5D,5DS,5DSR,6D Mark II,7D Mark II,50D,40D,30D,20D,10D,1DS,1DX,50D,40D,30D,20D,10D and Other Canon Cameras with 3-Pin Connection

Was: $67.88
Now: $33.94
(No reviews yet) Write a Review
SKU:
AN115501
UPC:
6970696041943
Condition:
New
Availability:
Free Shipping from the USA. Estimated 2-4 days delivery.
This Wireless Remote is designed for cameras that has a remote shutter socket. The system works at a 433MHZ frequency and has 16 available channels. In addition, this wireless remote system adopts a technology to allow the transmitter trigger the receiver without direct line of sight up to 30 meters. The transmitter can trigger the camera shutter at five modes: single shot, 5 seconds delay shot, 3 continuous shots, unlimited continuous shots and bulb shot/bulb lock. It works with Canon cameras with 3-Pin Connection, below are part of the compatible models: EOS 5D Mark IV,5D Mark III,5D Mark II,5D, 5DS, 5DS R EOS 1D,EOS 1D Mark II,EOS 1D X Mark II,EOS 1Ds, EOS 1Ds Mark II, EOS 1Ds Mark III,EOS 1D C,EOS 1D X,EOS 1D Mark IV,EOS 1D Mark III, EOS 1D Mark II N EOS 7D Mark II,EOS 7D,6D Mark II,6D EOS 50D,EOS 40D,EOS 30D,EOS 20D,EOS 20Da,EOS 10D,EOS D60,EOS D30,EOS 1V,EOS 3,EOS D2000 Important - How to use: 1. Install the CR-2 battery to the receiver and 23A battery to the transmitter. (Make sure to remove the plastic protective paper on the battery before installation) 2. Set the receiver and transmitter to the same channel (Normally the channel is already matched when you receive the package, so actually you don't need to set it, but it you ever reset the channel, make sure they are the same) 3. Once the batteries are properly installed and the channels are matched, when you press the shutter button on the transmitter, both the LED bulb on the transmitter and receiver will light up.(If not, please check if the battery is installed correctly or the battery is dead) 4. Once the transmitter matches the receiver, connect the receiver to the camera via the camera connecting cable which is included in the package,then set the transmitter into the working mode you want and finally press the shutter button to take a photo wirelessly.