Fitment
1994-1997 Volvo 850 Wagon (Rear Hatch)
1998-2000 Volvo V70 Wagon (Rear Hatch)
Location
Rear Hatch
Item-Offered
2pcs New Left+Right Lift Supports
Cross-Reference
Can Replace These Part Numbers:
4138,SG415009,WGS-412,LSC-0412
Material
Steel
Color
Black
Installation-Instructions
Always replace both lift supports to ensure top performance and to prevent twisting caused by uneven loading.
1. Turn off ignition. If old lift support has a window demister electrical connection, carefully disconnect the fittings.
2. Before removing old lift supports, examine any fittings supplied to determine which components must be re-used.
3. Have someone hold the hatch, bonnet, boot or rear window open while replacing the lift supports.
4. Loosen the fasteners, remove one end while being prepared to fight the pressure in the strut, move the end so it's away from the bodywork, remove the other end, install that end of the new one, wrestle the other end into place and tighten up.
5. Make sure all connectors and hardware are in place, tight and secure. Reconnect electrical terminals at both ends of the gas-charged lift support, if applicable to your car. Retain plastic end caps, if applicable to your car.
WARNING:
Use safety stands whenever a procedure requires you to be under the vehicle.
1994-1997 Volvo 850 Wagon (Rear Hatch)
1998-2000 Volvo V70 Wagon (Rear Hatch)
Location
Rear Hatch
Item-Offered
2pcs New Left+Right Lift Supports
Cross-Reference
Can Replace These Part Numbers:
4138,SG415009,WGS-412,LSC-0412
Material
Steel
Color
Black
Installation-Instructions
Always replace both lift supports to ensure top performance and to prevent twisting caused by uneven loading.
1. Turn off ignition. If old lift support has a window demister electrical connection, carefully disconnect the fittings.
2. Before removing old lift supports, examine any fittings supplied to determine which components must be re-used.
3. Have someone hold the hatch, bonnet, boot or rear window open while replacing the lift supports.
4. Loosen the fasteners, remove one end while being prepared to fight the pressure in the strut, move the end so it's away from the bodywork, remove the other end, install that end of the new one, wrestle the other end into place and tighten up.
5. Make sure all connectors and hardware are in place, tight and secure. Reconnect electrical terminals at both ends of the gas-charged lift support, if applicable to your car. Retain plastic end caps, if applicable to your car.
WARNING:
Use safety stands whenever a procedure requires you to be under the vehicle.
