Jahyshow 3157 4157 3057 50W 8 Ohm LED Lights Load Resistor Adapter Fix Hyper Flashing Rapid Blinking Canbus Error Code Eliminator Warning Canceller for Turn Signal Reverse Backup Daytime Running DRL

Features: Set of 8 Ohm 50W LED load resistors for signal light upgrades. Bypass low energy draw and eliminates error indications for hyper-flash (quick flashing) or burnt out bulbs generated by the on-board computer scan. It is compatible with the majority of vehicles equipped with CANBUS systems. No hassle plug-and-play kit that requires no retrofitting. The metal piece on the wiring does get hot during use, please mount it to metal surfaces and away from plastic to avoid any issues. Manufactured with quality material that is weather-resistant. Specifications: For 12 volts Double-filament sockets 3057 3155 3357 3457 4157, etc -Solution for "bulb out signal" / "OBC error message" after installing SMD LED light bulb -Solution for fast turn signal blinking response after installing SMD LED light bulb Note: - This set of load resistor is meant for use with standard sockets, please double check that you are not purchasing it for your vehicle equipped with CK (polarity sensitive) sockets because it could possibly blow out your bulbs. - If it doesn't light up, just flip it 180 degrees then it should light up. - When using LED bulbs for turn signal, you will need to use the above load resistor or decoder set to prevent hyper flash or bulb malfunction. These load resistors WILL get really hot, as much as a working halogen bulb. Please mount them steadily onto metal surface