Iron on Patches Letters 26pcs A-Z Alphabet Patches DIY Embroidered Patches for Hats Jackets Shirts Vests

The steps are as follows 1. Keep the back side clean before ironing, and adjust the temperature to the temperature suitable for the clothes according to the method of using the iron. 2. Put the cloth on the appropriate position (do not tear off the glue), burn it back and forth a few times, usually about 15 seconds. 3. In order to prevent burns, you can put a thin cotton cloth on the cloth (must be cotton non-fading cloth), check the edge after ironing to see if it is hot, and burn a few times on the edge. 4. According to the thickness of the decal to determine the temperature, thicker, must be higher temperature, hot time is longer, for a particularly thick cloth, you can burn a few times on the back. 5. Special Note: For cloth with bright pieces or bright surface (because the sequins are all plastic products), be sure to put a layer of cloth and use low temperature ironing (less than 150 degrees Celsius), or use a steam iron directly. Or put a layer of damp cloth on top. In order to avoid the temperature is too high, the plastic sheet melts. 6. After ironing, use a needle thread to sew a few stitches on the side of the cloth, which is more firm and very docile. Kindly Notes: Please allow little color difference due to different camera or light environment. Please allow slight size deviation due to manual measurement. Would you encounter any problems, please email to us and we will try our best to meet your satisfaction! If you are satisfied with our service and product, you kindly 5 stars positive feedback will be highly appreciated. Hope you have a pleasant shopping experience. Thank you very much!