IJJ ZVS 20A 1000W Low Voltage Induction Heating Module Flyback Heater Driver Board

A flyback drive circuit, which is used to drive the ignition coil, as did the Zero Voltage Switching, masses of fans called them "ZVS circuit". Because of its big power, low heat, simple and reliable by fans are widely used in the drive spark gap tesla coil (SGTC) and Jacob, ladders, Marx generator, etc. This ZVS driver kit support DC 12-30V voltage input and high voltage output up to 800 times of the input votlage with high arc generated up to 5cm ideal electricity science experiment. Specifications: Input Voltage: DC 12-30V Input Current: >5A(under 12V), >10A(over 15V) Working Frequency:30-50KHz Arc Length:2-8cm(depens on power supply) Board Size: 90 X 90mm/3.54 X 3.54inch(L*W) Package Included:1X ZVS Flyback Driver Board Warm Tips: 1. The power supply should at least 12V 5A,if the power supply is too low lead to the low power input, then the two MOS will connect at the same time, this will damage it. (when use the induction heating function, the power supply suggest 24V 15A) 2. When there is no loads connected, please do not power on the module, otherwise it will produce high frequency noise to damge the MOS.