Save time, money, and frustration by getting on paper with only a few shots for fine tuning.
-
Instructions
- Unscrew the back cap from the bore sight by turning counter clockwise
- Stand the boresight on a flat surface with the laser side pointing down
- Insert 3 batteries (+ side up) inside the rear opening. This unit will work with 3 batteries and comes with an additional set.
- Carefully push down & turn the screw cap clockwise to tighten the cap (the laser is now on)
- Place in your rifle's chamber and close the bolt
- To remove - open the bolt if it does not automatically extract manually remove the unit by tilting the rifle's barrel upward (always practicing safe firearm practices)
- Unscrew the back and remove the batteries to turn the unit off Technical Information
- Caliber or gauge specific bore sight - This laser unit fits the .223 chamber.
- Red laser has a wavelength of 635-655nm
- Human Accessible Power Output / Maximum Output Power: <5mW (milliwatts)
- Laser Hazard Class llla. The laser hazard class has been determined by an independent laboratory and complies with the 21 CFR 1040.10 and 1040.11.
- Six (6) AG3/LR41 button cell batteries provided; this unit will work with three (3) batteries.
- Recommended distance is 25 yards indoors.
- Will display a 2" dot at 100 yards
- Brass outer case
- Operating temperature 14 degrees F to 122 degrees F
- Includes re-sealable blister pack
- Lifetime Warranty
-
CAUTION
DO NOT ATTEMPT TO SHOOT THE LASER BORE SIGHTER.
ALWAYS PRACTICE SAFE HANDLING PROCEDURES.
DO NOT POINT LASER INTO EYE.
