FYSETC PEI Magnetic Flexible Heated Bed 235x235mm 92x92 inch for Ender 3 Ender 3X Ender 3 ProEnder 3 ProxEnder 5 Ender 5 Pro

Feature: PEI Sheet Use: Thickness: 0.17mm Compatible with PLA ABS PETG TPU and other most filaments. The Polyetherimide sheet comes with 3M 468MP adhesive already laminated to the PEI. Apply the PEI with slight pressure and at an angle to prevent and minimize air bubbles. Once applied set the print bed to 60C and apply pressure evenly across the PEI in a sweeping fashion to firmly set the adhesive. Please use a towel to avoid getting burned. Level the bed and set the height of the nozzle before printing. About How to install the PEI well on the Steel spring: clean the steel spring with some alcohol; rip off the PEI 3M adhesive, spray some alcohol on the PEI surface, then directly stick on the steel spring surface, rip off the PEI dustproof film When the print is completed, let the bed cool, and the part will be easy to release from the PEI surface. Parts are actually easier to remove if released before the bed becomes completely cold. Magnetic Base: Magnetic base that is adhesive-backed for easy installation PEI Sheet Maintenance: Clean in between prints with isopropyl alcohol and a lint free rag. Acetone can be used instead of isopropyl alcohol, but the bed must be cold if acetone is used. Optionally, light sanding with 600-1000 grit sand paper can be done after lots of printing to give the PEI sheet more life. Package Includes: 1X 235mm Steel Spring 1X 235mm PEI 1X 235mm Magnetic sticker B side