FusedLine Single Dose Hopper with Silicone Bellows and Anti-Popcorning Weight | Compatible with Eureka Mignon Series | Black

This listing is for the single dose hopper only. Grinder NOT included! To install the Single Dose Hopper onto your grinder: 1. Remove the original hopper from your machine and clean all old beans and grounds from the grinder. A vacuum cleaner works best. It is essential that the grinder inlet is free from all beans and grounds to ensure a secure fit. Note: Do not use water to clean the grinder as this can rust your grinder burrs. 2. Insert the hopper into the grinder inlet by aligning the slot. Press down to ensure the hopper is fully inserted and tighten the locking screw on the back of the machine. To use the Single Dose Hopper: 1. Measure out your dose and dump the beans into the hopper. Tip: the silicone bellows works great to measure and transfer your beans! 2. If you purchased the anti-popcorning weight, place it on top of the beans. 3. Set the silicone bellows on top of the hopper. 4. Press the grinder trigger to begin grinding. 5. Once all the beans are ground, give the silicone bellows a few gentle pumps to purge your grinder. Note that this works best while the grinder is spinning; restart the grinder if it has stopped. You can also adjust the grind time to ensure all beans are ground and there is extra time to purge the grinder. Also, there is no need to remove the anti-popcorning weight for this step. 6. Enjoy your freshest cup yet! **The bellows is compression molded silicone. The hopper additively manufactured with extremely high quality standards.