Brand New Code Alarm GOH-PCMINI Remote Fob with Random Logo (but is compatible with any Vehicle make the same 1 button remote FCC ID: GOH-PCIMI) and Part No. 3671A10247510
All of our remotes are tested and guaranteed to work with your vehicle 100% of the time - or your money back. A fresh battery has been installed and the remote is ready to be programmed to your vehicle. This remote is user programmable. The programming procedure is as follows:
METHOD #1
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored.
If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running in certain instances and could re-engage the starter motor.
The Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or single injector.
TO LEARN TACH:
1. Turn the ignition key to the ON position.
2. Press and release the program push-button switch 3 times.
3. Immediately turn the ignition key OFF.
4. Hold the program push-button switch ON, then start the vehicle using the ignition key
5. When the unit senses the tach signal, the parking lights will flash
6. Release the program push-button switch. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored and the unit is now out of the program mode.
METHOD #2
1. Turn the ignition to the on position.
2. Press and release the programming switch 3 times.
3. Press and hold for 3 seconds, the button of the transmitter you wish to add until the parking light flashes indicating the transmitter has been learned.
Repeat step 3 for up to a total of 4 fobs
All of our remotes are tested and guaranteed to work with your vehicle 100% of the time - or your money back. A fresh battery has been installed and the remote is ready to be programmed to your vehicle. This remote is user programmable. The programming procedure is as follows:
METHOD #1
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored.
If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running in certain instances and could re-engage the starter motor.
The Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or single injector.
TO LEARN TACH:
1. Turn the ignition key to the ON position.
2. Press and release the program push-button switch 3 times.
3. Immediately turn the ignition key OFF.
4. Hold the program push-button switch ON, then start the vehicle using the ignition key
5. When the unit senses the tach signal, the parking lights will flash
6. Release the program push-button switch. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored and the unit is now out of the program mode.
METHOD #2
1. Turn the ignition to the on position.
2. Press and release the programming switch 3 times.
3. Press and hold for 3 seconds, the button of the transmitter you wish to add until the parking light flashes indicating the transmitter has been learned.
Repeat step 3 for up to a total of 4 fobs
