Flysky FS GT2E AFHDS RC Transmitter and Receiver with FS A3 Receiver 2A 2 4ghz 2CH Radio Remote Controller for RC Car Boat

Matching Code/ Binding: All receivers are already paired with their respective transmitter during production. If you want to bind it with another transmitter, please follow the instructions below. 1.Ensure you are using AFHDS2A system. 2.Correctly install the battery inside 2.4G transmitter w/o powering it on. 3.Insert the binding plug into the BIND channel slot on the receiver. 4.Using a correct receiver battery pack, plug it into VCC channel slot on the receiver. At this time, the LED on receiver should flash, indicating receiver has entered bind status. 5.Press and hold the binding button on transmitter, and then switch on the transmitter. 6.Observe the LED light on the receiver. If LED stops flashing and system lit permanently. The binding procedure is completed.(This process takes approximately 5S) 7.Release the binding button on the transmitter and unplug the bind cable. 8.Install the servos to test. 9.If the system does not work properly repeat the procedure. (The above binding instruction is only suitable for any Flysky 2.4G products) Transmitter Specifications Channels:2 Model Type:Car/Boat RF Range:2.405-2.475GHz Bandwidth:500 KHz Band:141 RF Power:No Higher than 20dBm 2.4GHz System:AFHDS2A/AFHDS Code Type:GFSK Sensitivity:1024 Low Voltage Warning:under 4.2V DSC Port:3.5mm; Output: PPM Steering Range: 70° L: 35° R: 35° Throttle Range: 45° F: 35° B: 15° Charger Port: No Antenna Length:26mm Power:6V DC 1.5AA*4 Display Mode:LED indicator Certificate:CE, FCC Receiver Specifications Channels:3 Model Type:Car/Boat RF Range:2.405-2.475GHz Bandwidth:500 KHz Band Sum:141 RF Receiver Sensitivity:-98dBm 2.4G System:AFHDS 2A Code Type:GFSK Sensitivity:1024 Power:4.0~6.5V DC Antenna Length:26mm Package Included 1 x FS-GT2E Transmitter 1 x FS- A3 Receiver 1 x Instructions