Specification:
Control chip: SSD1306
High resolution: 128 X 64
Viewing angle:> 160 °
Voltage: 3V ~ 5V DC
Interface type: Default 4-wire SPI
Switchable rear resistor to use 3-wire SPI, IIC interfaces
Number of pins: 7
Working temperature: -30 -70°C
Interface definition: GND - Power ground VCC - Power + 3.3-5V D0 - SPI clock line for SPI interface and IIC clock line for IIC interface D1 - SPI data line for SPI interface and IIC data line for IIC interface RES - OLED reset, OLED needs to be reset once after power-on DC - SPI data/command selection pin, used to set IIC address when IIC interface CS - OLED SPI chip select, active low, if you do not want to use must be grounded
Wiring method: Wiring 1: MCU hardware SPI connection method: If there is only one device on the SPI bus, you can directly ground the CS of the OLED screen, which saves an IO.
Wiring 2: MCU IO analog SPI connection mode: If there is only one device on the SPI bus, you can directly ground the CS of the OLED screen, which saves an IO.
Wiring 3: MCU analog IIC connection method: IIC address: DC is low = 0x78 DC is high = 0x7A Generally DC grounding
Wiring 4: MCU hardware IIC connection method: IIC address: DC is low = 0x78 DC is high = 0x7A Generally DC grounding
Package Included: 5 X 0.96 Inch 7 pin OLED LCD display module 5 X Plastic stoage box
FBHDZVV 5PCS 0 96 OLED Display Module 128x64 SSD1306 SPI 0 96 inch LED Driver Chip SSD1306 7Pin IIC I2C SPI Serial Yellow Blue Display Compatible with Arduino and Microcontroller DIY KIT
Was:
$103.46
Now:
$51.73
- SKU:
- ST383981
- UPC:
- 794497947046
- Condition:
- New
- Availability:
- Free Shipping from the USA. Estimated 2-4 days delivery.