Etopars 157 4M Z Shape Car Door Trim Edge Moulding Rubber Weatherstrip Seal Strip Auto

Installation method: 1. The body must take before pasting paste parts deal with clean, do not have any stains and moisture. 2. After pasting to keep clean, do not suffer long against dirt and water, otherwise it will lose tack 3M tape effect, there will be off open plastic phenomenon. 3. Paste selected bits identify the paste will start from the front side door seal the lower end of the rod began to carry out a little pressed paste, be careful not to pull the seal a little action, try to keep the prototype seal slowly aligned identify the Paste the path carefully paste; position in the corner of the door frame, seal very gentle to pay attention to bend away type, do not bend too fast aesthetic impact. Figure fast not seek hurry, so as to ensure results. 4. All pasted into After the check, after a while the time were thoughtful and meticulous hand pressing it, you can call it a day, and this time it is best not to close, wide open doors on 20 minutes after a closed door, Then the best other 3 - 5 hours before normal use to open the door. 5. complete ban after pasting a hand to pull the seal ban car washing water on in three days as much as possible not to repeatedly switch the door within 24 hours. Package Include: 157" ( 4 Meter ) Car seal strip