ENQIMAOYI 10PCS 12MM 6PIN RGBWW LED Strip Connector LED Strip to Strip Connection Use Terminals for Waterproof RGB+CCT LED Strip

NOTE: Make sure your LED light strip is 12mm width 6 pin IP65 WATERPROOF RGBCCT RGBWW strip light. Not work for non-waterproof or 10mm width led strip lights. Ensure your Wire Diameter is within range 20AWG-22AWG /0.34~0.75 mm2 and without stripping wire. Installation Guides --Strip End Ensure your LED light strip is waterproof 12mm width and has 6 contacts (+, B, R, G,W,W). All contacts are clean and cut the strip straightly. Open the transparent cover of connector up to 90 degrees. Peel off the 3M tape around the cutting line area on the back of the LED strip, then insert the LED light strip into clasp side, with the 6 contacts of the LED strip sitting on the 6 pins of the clasp. (Note: No need to peel off the silicone on the surface of led strip around soldering line area) Close the clasp down with force by pliers. Package Content: 10pcs 6pin LED strip to strip Waterproof Connector.