ENOMAKER ST-PLA (PLAPlusPlus) 3D Printer Filament 1.75MM 1kg(2.2LBS) Spool Improved by New Formula for Creality CR-10 V2 Ender 3/5/6/pro/plus, Blue

ST-PLA is improved PLA filament by new formula and special machine, toughness is several times tougher than most PLA on the market.It can solve the PLA brittle problem! Widely Compatible with Creality, Makerbot, FlashForge, Ultimaker, XYZprinting, Alunar, Monoprice and other FDM 3d printer! Name: 1.75mm ST-PLA 3D Printer filament Color: Blue Net Weight: 1kg/roll Recommend Printing Temperature: 195~220°C Heat Bed Temperature: 45~55°C Recommend printing speed: 30-80mm/s Diameter & Tolerance: 1.75±0.03mm Advantages for ST-PLA 3d filament 1. New Formula,with exclusive formula,the bonding between layer and layer is rather good. 2. Cold Resistance, under -10?, the toughness is still perform good! 3. Moisture Resistance, no longer need to worry that the filament would become brittle when it stay in your printer overnight, it stays in air for 6 months still have good toughness, but keep it away from dust. 4. Impact Resistance is increased about 3 times,make your prints not easy to break. 5. Toughness is increased by several times than normal PLA.Better than PLA+. 6. Safety: Little to odour, comply with RoHS. Tips1. When finished printing, for the left of filament, be sure to insert end of filament into holes to avoid being tangled for next time! 2.When start to use the filament, make sure to hold the start end of filament tightly,once let go the filament, the start end of filament might fall into the first few circles of loose filament, and this might cause filament get tangle. In this situation, filament could only pull out about a dozen meters. Once let go the start of filament,to avoid tangle, you can unwind the filament for 20-30meters, and then wind it by hand. 3.The spool have been changed, no gap any more, changed to holes.