ELENKER DC 12V 10A Relay 1CH Wireless RF Remote Control Switch Transmitter with Receiver

ELENKER 1CH wireless RF Remote Control Switch Transmitter with Receiver Receiving Board Parameters Operating Voltage: DC 12V Operating Frequency: 315 MHz Receiver Sensitivity: >-105dB Maximum Load: 7A 240V AC / 10A 24V DC Encoding Type: Learning Code Board Size: 34 x 31 x 18mm Weight: About 30g Remote Control Parameters Operating voltage: 12V (12V 23A Battery) Frequency: 315MHZ Encoding Type: Fixed Code Firing Range: 100 meter(open) in theory, 15%-30% in reality Size: 35x 55x 13mm Shock Resistance: 4.7M Battery for Transmitter :23A 12V Weight: About 24g Note: This ELENKER Remote Control Switch has been set up before leaving the factory, and the pairing has been completed, no need to pair again. Please connect the wiring according to the wiring diagram. Turn on the power, if the power led is not lit, the line is not connected, please check the line first. If the wiring is correct and the power led is lit but cannot work, please clear the code first and then learn the new code. Clearing Code Method: --- Turn on the power, power led lit, learning led will light for 3 seconds and then go out. --- Press and hold the learning key. --- The learning led will turn off after 8 seconds. --- Complete clearing code. Learning Code Method: --- Turn on the power, power led lit, learning led will light for 3 seconds and then go out. --- Press the learning key once. --- At this time, the learning led lights up. --- Press the remote control button, the learning led will light off --- Complete learning code. Package Included: 1 x ELENKER Remote Control Switch Transmitter