E-Simpo 4W G23 LED Bulb 2-Pin LED PL Retrofit Lamp CFL 7W Replacement 180° View Angle Daylight 6000k LED PL Horizontal Recessed Down Light Bulb-Need Bypass Ballast- -Cold White 4W 135mm-

E-Simpo 4W G23 LED Bulb 2-Pin LED PL Retrofit Lamp CFL 7W Replacement 180° View Angle Daylight 6000k LED PL Horizontal Recessed Down Light Bulb(Need Bypass Ballast) (Cold White, 4W 135mm) Specification Input Voltage: 85-300V AC Power: 4W NO Dimmable CRI>82 LED: SMD2835 Brightness: 4W 350-450Lumens Color Temperature: Warm White 3000-3500K; Cold White 6000-6500K Please check the PL Lamp fixture or table light fixture for allowed install length before you decide. Size: 4W: L135*D27mm/L5.3"*D1.0" Application: 3W is used to Replace 2-Pin CFL PL-S 5W 4W is used to replace 2-Pin CFL PL-S 7W Note: 1. Please check if the inside ballast is inductive ballast or electronic ballast; 2. If it is inductive ballast, you can use this LED lamp directly, just plug and play. 3. If it is electronic ballast, the led driver can not work compatibly with the electronic ballast, so you have to bypass the electronic ballast. Otherwise the LED Lamp witll get flicking, burnt, smell, damaged. How to bypass the ballast? 1. Turn Off the Power. 2. Find the Ballast. Usually it is embeded inside the ceiling fixture. Pls pull off the existing PL lamp, reflector. Leave wire in junction box. and find the ballast. 3. Normally, the Ballast has a black and white wire on the input side (AC input side, 100V -120V for North America). It also has two red and two blue output wires. To bypass this ballast, please cut all the Input and output wires, so total 6 wires cut. 4. Then, you can connect the two red wires to the black wire. 5. Next, connect the two blue wires to the white wire. now ballast is bypassed.