DIY Souvenir Hand Casting Kit Couples Wedding Holding Baby Plaster Mold 3D Plaster Handprint Footprint Baby Mould Hand and Foot Casting Prints Kit Cast Keepsake Gift for Adult and Child

? Souvenir Hand Casting Kit Couples Wedding Holding Baby Plaster Mold ? Feature: ? Net Of Model Powder: 100g ? Net Of Clone Powder: 100g ? Dosage: ? 0-1 years: One hand (50g) one foot (100g) ? 1-2 years:One hand (100g) one foot (150g) ? 2-3 years:One hand (100g) one foot (200g) ? 3-5 years:One hand (200g) one foot (250g) ? Adult:One hand (300g) ? Couple hands:One hand (600g) ? Ready to work: ? 1. a one-time cup: thicker, bigger, transparent the best (if the baby does not put in, you can consider the cup of tea) ? 2.30-35 degrees pure water or tap water (please do not use mineral water) ? 3. chopsticks,Spoon ? 4. Thermometer ? 5. Stopwatch: mobile phones, computers are, you can watch the clock ? Steps: ? 1. Take clone powder 50 grams, add 1.2-1.5 times the volume of water mixed, mixing, then cloning powder and water mixture into a purple paste liquid, stir it, about 1 minute or so purple gradually receded, immediately Baby's little hands or feet into the liquid, the baby's little hands or feet must be soaked in the liquid inside ? 2. Take the model powder 50 grams, add 1 / 3-1 / 2 of water, water do not put too much, as long as the powder and water mixture into a liquid, the more concentrated the better, even after mixing, slowly poured into the colloid , Down a little, Akira look, to avoid the gas plug in the inside. ? 3.2-5 hours after the or hand can be used to slowly open the colloid, must be carefully poke, not anxious. ? (Note: the surface of the work of a little powder can be rinsed with water, placed in a ventilated place to dry, it is recommended to dry for more than 24 hours.) ? Package Include: ? 1PC Net Of Model Powder ? 1PC Net Of Clone Powder ? 6PC Paint ? 1PC Brush