DIY Led Tree Kits LED Flashing Tree DIY Kits Electronics Soldering Colorful Tree DIY Module PCB Board Soldering Practice Learning Kits

Parameter:     1>.Work Voltage:DC 4.5V~5.5V     2>.Work Current:500mA     3>.Power Type:Mini USB     4>.Work Module:Switch Control     5>.Color:RGB LED     6>.Work Temperature:-40?~85?     7>.Work Humidity:0%~95%RH     8>.Size(Installed):88*88*160mm Installation Steps(Please be patient install!!!):     1>.Step 1: Identify the LED pins. The rectangular pad connects to the longest LED pin.The pins of other LED are inserted into the corresponding pads in sequence.     2>.Step 2: Place LED on pad and then bend LED and keep about 2mm distance between PCB edge and LED body.And then fixed LED pin.     3>.Step 3: Install 1pcs 10Kohm Metal film resistor at R1 and 1pcs Photoresistor at RP on the bigger PCB.     4>.Step 4: Install 1pcs MINI USB Female Socket at J1 on the bigger PCB.     5>.Step 5: Install 1pcs DIP-16 IAP15W413AS-35I at U1 on the bigger PCB.There is a dot on one corner of the IC and there is a mark on PCB where the IC can place on.These two marks are corresponding to each other and are used to specify the installation direction of the IC.     6>.Step 6: Install 1pcs Toggle Switch at S1 on the bigger PCB.     7>.Step 7: Install 12Pin Male Pin at black area on 2pcs the smaller PCB.     8>.Step 8: Fix 3pcs PCB.     9>.Step 9: Install 1pcs 10mm RGB LED at the top.     10>.Step 10: Connect to power supply and enjoy the effect.