DieseRC AC 110V 120V 240V Radio Control Switch 2 Channels 433Mhz RF Wireless Relay Receiver Board and 2 Transmitters with 4 Buttons for Electric Awning, Garage Door, Motor, Light

Package includes: 1 x relay receiver card (with case). 2 x transmitters (contains one battery). 1 x product manual. Parameter: - Receiver operating voltage: AC 85V~250V. - Input / Output Vlotage: 1~250V - Rest current: <5MA - Maximum current: 10A - RF frequency: 433MHz - Operating temperature: -30~+80 - Receiving sensitivity: >97dBm - Number of remote controls: 20 pieces - Support encoding: 1527 learning code. - RF operating mode: wireless reception superheterodyne ASK - Reception range: the open space is more than 50 metres. - Pin: COM,NO,NC - Operation mode: Momentary / Toggle / Lock Mode - Battery: 2 x CR2016 (container). Use: Momentary Mode: 1. Press and hold the button, the relay "1" will light up; 2. Release the button, this "1" relay will turn off. Toggle Mode: 1. Press the "A" button, the relay "1" will light up; 2. Press the "A" button again, this relay "1" will turn off. L Attached Mode: 1. Press the button "A", the relay "1" will light up; 2. Press the "B" button, the relay "2" will turn on, at the same time the relay "1" will turn off. Reset: Press the learning button 8 times (on the receiver). success. Note: After deleting the data, all remote controls can no longer work. Configuration 1. Press the learning button (once for momentary mode, twice for toggle mode, three times for locked mode). Wait 3 seconds; 2. Press the "A" button. Wait 3 seconds. 3. Press the "B" button. Success