Deebior 2pcs Rear Left Right Window Glass Lift Supports Strut Shocks Compatible With Chevy Blazer 95-05 2D/97-99 Blazer 4D and GMC Jimmy 95-05 2D/97-99 Jimmy 4D and Olds 97-01 Bravada w/Dropgate

Fitment:
1995-2005 Chevy Blazer 2-Door With Dropgate Only (Not Fit Liftgate Model)
1995-2005 GMC Jimmy 2-Door With Dropgate (Not Fit Liftgate Model)
1997-1999 Chevy Blazer 4-Door With Dropgate Only (Not Fit Liftgate Model)
1997-1999 GMC Jimmy 4-Door With Dropgate Only (Not Fit Liftgate Model)
1997-2001 Oldsmobile Bravada With Dropgate Only (Not Fit Liftgate Model)


Item-offered:
2pcs New Rear Left+Right Window Glass Lift Supports

Location
Rear Window Glass Left+Right

Parameters
Extended Length: 443mm
Stroke Length: 164mm
Compressed Length: 279mm

Material
Steel

Cross-reference:
Can Replace The Following Part Numbers: SG330019; 4642; LCS-0166; WGS-166; 901285; D95544; 819-5638; 613149; 

Warranty
1 Year's Warranty

Installation-instructions

1. Turn off ignition. If old lift support has a window demister electrical connection, carefully disconnect the fittings.
2. Before removing old lift supports, examine any fittings supplied to determine which components must be re-used.
3. Have someone hold the hatch, bonnet, boot or rear window open while replacing the lift supports.
4. Loosen the fasteners, remove one end while being prepared to fight the pressure in the strut, move the end so it's away from the bodywork, remove the other end, install that end of the new one, wrestle the other end into place and tighten up.
5. Make sure all connectors and hardware are in place, tight and secure. Reconnect electrical terminals at both ends of the gas-charged lift support, if applicable to your car. Retain plastic end caps, if applicable to your car.