Death Star Ice Cube Mold 2x Ice Cube Tray with Funnel _ Silicone Death Star Wars Ice Cubes for Whisky Ball Maker Silicone Mold 2_5 inch ice cube molds Rou

STEP 1 - Connect it carefully. Top and bottom parts should be lined up properly at the marked seam. So it shouldn’t leak.  STEP 2 - Fill the mold with water. Best water will be pure distilled water, + boil it twice before use. In a real rush, at least use distilled. (see user guide for more details).  Do not fill the mold all the way to the top. Stop just below the top opening (fill about 90% of the mold). Set your ice ball mold on a level surface in the freezer. If the mold is tilted, water can leak out.   TIP Before placing in freezer, wipe the outside, and place it on counter to make sure its assembled right, so it should not leak in the freezer.   STEP 3 - Freeze it till completely frozen. (see user guide for more details).  STEP 4 - Once frozen, separate the two parts of the mold.  If any of the ice balls stick to the mold, run cold or lukewarm water (not hot) over the bottom of the mold and the ice should release.   It will get easier to remove, the second and third time using the mold.   More tips and guidance in the attached user guide.