Dead Eyes Mooring Tools fix Tool for Wood Ship Model kit 1 pecs/Packet

Features Length 70 mm Width 55 mm Height 7 mm material: wood Excluding three-eyed pulley and line how to use : combine 1 and 2 part with glue , and fix with Screw 2. First, determine the distance between the top and bottom of the three-eye pulley set you are going to make, and the actual distance of the blue arrow point to the blue line in the figure below. 3.Then loosen the auxiliary slider tightening screw (the red circle position in the figure below), then slide down and down according to the blue arrow direction to adjust the slider, align the scale line on the slider (the yellow circle above) to the distance you actually need, tighten the tightening screw to fix the slider 4.Hold the three-eyed pulley in front and back of your finger and insert it into the fixing groove of the pulley of the auxiliary device from the side. It does not need to be too tight, as long as the pulley does not loosen and fall, as shown in the following figure (it should be noted that the upper and lower sides of the fixing groove of the pulley must clamp the cable groove of the pulley): how to use : combine 1 and 2 part with glue , and fix with Screw First, determine the distance between the top and bottom of the three-eye pulley set you are going to make, and the actual distance of the blue arrow point to the blue line in the figure below. Then loosen the auxiliary slider tightening screw (the red circle position in the figure below), then slide down and down according to the blue arrow direction to adjust the slider, align the scale line on the slider (the yellow circle above) to the distance you actually need, tighten the tightening screw to fix the slider, and then proceed to the following steps; Hold the three-eyed pulley in front and back of your finger and insert it into the fixing groove of the pulley of the auxiliary device from the side.