Creazy 3D Plaster Handprint Footprint Baby Mould Hand and Foot Casting Prints Kit Cast Gift

Application: Reproduce the hand or foot of your (god-) child three dimensionally and with accurate details. Advantage: Preserve every precious detail, capture tiny toenails, fingernails, dimples & footprints ,even if baby wiggles. Dosage: -0-1 years: One hand (50g) one foot (100g) -1-2 years:One hand (100g) one foot (150g) -2-3 years:One hand (100g) one foot (200g) -3-5 years:One hand (200g) one foot (250g) -Adult:One hand (300g) -Couple hands:One hand (600g)Ready to work: 1. a one-time cup: thicker, bigger, transparent the best (if the baby does not put in, you can consider the cup of tea) 2.30-35 degrees pure water or tap water (please do not use mineral water) 3. chopsticks Spoon 5. Thermometer 6. Stopwatch: mobile phones, computers are, you can watch the clock Steps:(usually within one year of the baby a hand 50 grams, one foot 100 grams) 1. Take clone powder 50 grams, add 1.2-1.5 times the volume of water mixed, rapid mixing, then cloning powder and water mixture into a purple paste liquid, stir it, about 1 minute or so purple gradually receded, immediately Baby's little hands or feet into the liquid, the baby's little hands or feet must be soaked in the liquid inside, do not stick to the walls of the cup, while ensuring that the baby's hand or feet do not move, about 2 and a half times the liquid will solidify, please Keep 4 minutes and then remove the baby's hand or feet, can be removed before and after the move, let the air go, slowly removed. 2. Take the model powder 50 grams, add 1 / 3-1 / 2 of water, water do not put too much, as long as the powder and water mixture into a liquid, the more concentrated the better, even after mixing, slowly poured into the colloid , Down a little, Akira look, to avoid the gas plug in the inside.