Creality Upgraded 3D Printer Platform Glass Plate Panel 310X310MM Heated Bed Glass Print Bed Build Surface with Microporous Coating for for CR-10 CR-10S

About the Creality 3D Printer Glass Plate Heat Bed for CR-10 CR-10S 1.Better adhesion: Creality superplate covered by microporous coating, shows strong adhesion during printing. 2.High-performance: The silicon carbide glass is of chemical stability, high heat conductivity coefficient and good wear-resistance and can withstand extreme temperature. 3. Reliability: The special coating is inorganic, with its hardness of 7-8 Mohs and heat resistance up to 400 ?. 4. Easy to clean with water or alcohol. Easy to remove your print by hand or with a scraper. ? How to use 1.Clamp the platform to the printer's hot bed. 2.Place the A4 paper on the platform for leveling, and the distance between the nozzle and the platform keeps the A4 paper moving freely. 3.Clean the platform surface with alcohol/water (If there is sweat or oil on the platform, which will lead to stickiness.), Suggested bed temperature may vary depends on the filament material. 4.After finish printing, the viscosity of the platform will gradually decrease as the temperature decreases, and the model can be taken after the temperature of the platform is lowered. Temperature settings for different filaments: PLA:50-70oC Flexible filament: 50-70oC ABS:100-125oC (110oC is recommended) PC:100-130oC (120oC is recommended) Nelon:90-120oC (110oC is recommended) PP:100-130oC (120 oC is recommended) PETG: 50-70oC Specification: Material: Special Glass + microporous coatings Item size: 310*310*4MM/12.2*12.2*0.16IN PLS NOTE?Move the nozzle the front/left leveling screw and adjust the platform height by turning the knob underneath(The thickness of a piece of A4 paper). The nozzle is too far away from the platform.so that consumables can not adhere to the platform. The nozzle is too close to the platform,and the filament are not extruded enough.even scraping the platform.