Co2 Cylinder Refill Adapter Connector Kit CGA320 Thread Set Replacement for Sodastream Tank Home Filling Soda Maker Cylinder Refill Adapter Kit

Specifics: Material: Brass Thread: TR21-4 (Sodastream Cylinder) to CGA320 (Large CO2 Tank) Quantity: 1Set Note: New Version fittings set may slightly different from the picture Package Included: 1 x CO2 Refill Adapter 1 x Fittings Set When using, be sure to following these important points: That the seals goes in the correct location. So when the soda filling adaptor arrives, please make sure to use the correct seal in the correct side. Make sure to put the soda cylinder on the correct side. The soda cylinder thread can actually fit both sides of this adaptor, but the CO2 cylinder only fit's into the ROUND SIDE. As a result you MUST put the soda cylinder into the HEXAGONAL SIDE. Information of Filling the newer Co2 cylinder with filling protection valve(6mm wide valve pin) Unlike the other cylinder valves, this valve must be filled with a slow increase in pressure. When refilling, it is important that the pressure in the first few seconds is very low, only the cylinder valve remains open. The hand-wheel is therefore open at the beginning only slightly and very slowly until some gas flows through (this can heard). Wait about 10 seconds and then turn the hand wheel slowly by hand half a turn further on. After another 10 seconds, the hand wheel can be turned all the way. Wait about 30 seconds until you hear no gas flows and turn the hand-wheel to back. After, filling is complete. The cylinder should be empty. Pre-Cooled cartridges will get quite full. About Us: It's nothing about us. It's all about you. As informed above, the door to our Customer Service is constantly wide-open to you. If you were having any question, or just looking for someone to chat with, please feel free to contact us through Messages.