Attention Please!!!
Firstly, during installation, all permissions of the JXLCAM APP need to be allowed, otherwise the APP will not work properly.
The device does not support WIFI signals in the 5.8G band, only support 2.4GHz(5G is not supported).
If the blue indicator is slow flashing/or no longer flicker or cannot be connected, long press the reset button for 5 seconds to reset.
You can't successfully distribute the network when the power is insufficient. Before use, please do not connect and charge first. If it has been connected before charging, you should press and hold the reset button for 5 seconds to turn it on again. Confirm that there is a available WIFI near the device, turn on the device, flash the blue indicator light quickly, and the device is in a state to be connected. Check if the blue light is flashing fast, when it flashes fast it means searching for network.
The motion detection alert function only supports viewing in the APP, no mobile phone push (It must be opened on the APP page to use it and cannot push after exiting the APP).
When there is no WIFI in the environment, you can use AP mode to connect, which is valid for no more than 10m, which can achieve localized video viewing.
When the nearby WIFI signal is weak, the image will be stuck if the network is not successful or the network is successful. Click the "Refresh Page" icon in the upper right corner or the "Play" button to re-enter.
When the device fails to configure the network, please check whether the router and WiFi password are configured correctly, keep your mobile phone and camera close to the router when registering for the first time. Delete redundant WIFI accounts and keep only one.
It is necessary to maintain sufficient voltage and connect to the APP settings from a place with strong WIFI signal.
No power leads to shutdown, please long press the reset button for 5 seconds after booting, and then co
