Cell Phone Stand Resin Mold DIY Silicone Mobile Phone Holder Epoxy Casting Molds for Craft Cell Phone Bracket -red-

Product description Thank you for visiting our store. Please read the whole description about the item. Specification? · Material: High quality silicone · Size: as shown in picture · Package Included: 1x Silicone Cell Phone Stand Resin Mold Set How to Make a Resin Mold: 1. Pour resin into measurement cup, slowly stir to release bubbles. Adding glitter or pigment into it if you need. 2. Pour it into your mold and slowly stir. Allow to stand for 24 hours and take it out. How to De-mold: Usually, most of the resin pieces could pops out from the mold easily. There are 2 methods to make this process easier. 1.Use mold release to keep the resin from sticking to molds, and it is great for prolonging the life of molds. 2.After your resin pieces are completely cured, pour some soapy water into the mold. How to Clean and Store Silicone Molds: 1.You can wash it with warm water and soap or rubbing alcohol,  then use a soft cloth to wipe clean. Clean the mold after each use to maintain gloss and extend mold life. 2.Please store the resin silicone molds away from direct sunlight and dust. Warm Note: 1.No touching strong corrosive materials, otherwise it will shorten the life of the mold, and even lead to demoulding failure and mold damage. 2.Don't use a torch and heat gun to pop bubbles while resin in the molds,it will damage the molds. 3.Please allow slight dimension difference due to different manual measurement 100% Satisfaction Guarantee: 100% customer satisfaction is our pursuit.If you have any questions or problems with our products, please feel free to contact us and we will try our best to give you a satisfactory solution.