CB09 CB09U Graphtec Blade Holder with 10pcs Vinyl Cutter Plotter Cutting Blades 30/ 45/ 60 Degree

Growtech CB09 Graphtec Blade Holder with 10pcs 30 45 60 Degree Cutting Blades Product Specification: Blade Holder Material: Carbide Length: 51.8 mm(2.04 inches) Compatible with: Graphtec CB09U CB09 Cutting Blades Material: Hard Alloy Length: 19.8mm(0.78 inch) Diameter: 0.9mm Degree of Blade: 30 ° / 45 ° / 60 ° 30° Blades (Blue cap) for Cutting large fonts and thick materials which about 1mm.(eg: reflective material, masking tapes, etc.) 45° Blades (Red cap) for Cutting general fonts and vinyl film.(eg: vinyl for traffic sign, flocks, etc.) 60° Blades (Yellow cap) for Cutting very small font & intricate line-art logos.(eg: any thin vinyls) Notice: 1. Blade should not extend too long, generally within half a millimeter is better, while paying attention to extended blade longer properly when carve the small print, in order to avoid the blade holder take the carved strokes away. Suitably engraved small print with new cutter and slow down. 2. When the word carved with angular phenomenon, you should change the blade to eliminate the problem, if the phenomenon persists after change blade, it should be the holder problem. 3. When problem arise the blade holder, try a drop of oil in the bearing and rotate the blade several times to lubricate, if still unresolved, consider replacing the blade holder. Package Included: 1 x*Blade Holder 5 x*45° Cutting Blade 3 * 60°Cutting Blade 2 * 30°Cutting Blade 10 *Springs