Installation steps:
1. Clean the place to be pasted.
2. Remove the tape from the tip of the liner (make sure the tape fits inside the door).
3. Insert the liner into the edge of the door from the top until the liner is fully seated.
4. Use your thumb to press the liner along the edge of the door until it is fully seated.
5. Use scissors to cut off unused lining on the other door edges.
6. Let the liner dry on its own without getting wet for at least 10 hours.
(Note: If the trim is not soft enough to fit into the door, you will need to use a heat gun/blower.)
Specifications:
Package Included: 1*Car Door Edge Guard
Available in two lengths to choose from (16ft, 32ft)