Battery Terminal Connectors Military Spec with Negative and Positive Car Battery Terminal Protector Cover for Car Trunk Boat Marine RV

Was: $113.76
Now: $56.88
(No reviews yet) Write a Review
SKU:
TE460235
Condition:
New
Availability:
Free Shipping from the USA. Estimated 2-4 days delivery.
Adding to cart… The item has been added
Specification: Material: Zinc Alloy Positive Diameter: 19mm Negative Diameter: 17mm Long Bolt Diameter: Standard 3/8” Short Bolt Diameter: 5/16” Wiring: AT35-10 (AWG 2*3/8) Used for: Cars, Ships, Yachts, RV, etc. Package included: 1* Positive & Negative Battery Terminal Connectors 1* Red Cap +Black Cap 4* 3/4"x 1-1/2" adhesive lined heat shrink  4* T2 Copper Ring Terminal How do you connect the battery cables to the lugs? There are two ways to do this. You can crimp them or you can solder them. 1. Put the copper lug into a vise and fill it approximately halfway with solder. 2. Strip approximately 3/4" of insulation off the battery cable and place the cable on top of the solid solder. 3. Use a torch to heat the copper lug and apply a little bit of pressure to the cable. 4. The lug will heat up and the solder will melt causing the cable to slip into the lug. Once that has happened, take away the heat, let the lug cool, and apply heat shrink to the new connection. NOTE: 1. The included tinned copper lugs are only for 2 gauge wire, wire gauge of 2/0 is a larger diameter and needs a different lug. (Excluding battery cable) 2. If our battery terminal connector is loose on your negative terminal, please Do Not Over-tighten, it may crack the car battery terminal. Tighten just until you cannot move the battery terminal connectors on the battery post by hand