AUTOSAVER88 4 Inch Inlet Exhaust Tip 4 x 6 x 15 Inch Chrome Polished Stainless Steel Diesel Exhaust Tailpipe Tip Clamp-Bolt On Design

Installation Steps: Step 1: Clean the surface of your tailpipe. Clean the dirt and sand on your tailpipe with penetrating oil and a shop rag. (Make sure your tailpipe is at room temperature, and do not clean the surface of the tailpipe after don't do this when the car just went out). Step 2: Slide the exhaust tip into your tailpipe. Try to slide the exhaust tip into the tailpipe. You may encounter some resistance, so, if necessary, use automotive grease to lubricate the pieces if necessary. Cover the end of the exhaust tip with a towel and tap it into a place with a rubber mallet. Step 3: Fasten /w Weld the exhaust tip. Tighten screws and clamps to secure the exhaust tips. Should , if you worry that it is not tight enough, you can weld a joint between the edges of the tailpipe and the exhaust tip. Then, tThe installation is complete. Protect the Original Tailpipe: Protect the original exhaust pipe from sun and rain, to avoid prevent rusting and deformation. Nice Looking: The cChrome-plated finish, bright as a mirror, makes the exhaust tip looks shiny bright., and decorates your car nicely. Specification: Inlet Size: 3.4 Inch Inside Diameter Outlet Size: 6 Inch Outside Diameter Length: 152.0 Inch Overall Length Material: Chrome-PlatedBlack Paint Finish Stainless Steel Package: 1 piece exhaust tip. Note: Please measure the size of your exhaust pipe prior tobefore purchase of this exhaust tip.