Autosaver88 3 5 Inch Inlet With a Turn Down Exhaust Tip Black Paint Finish Stainless Steel Material And a 3 1 2 Inch Inlet 12 Inch Long Bolt On Installation Design

Installation Steps: Step 1: Clean the surface of your tailpipe. Clean the dirt and sand on your tailpipe with penetrating oil and a shop rag. (Make sure your tailpipe is at room temperature, and do not clean the surface of the tailpipe after the car just went out). Step 2: Slide the exhaust tip into your tailpipe. Try to slide the exhaust tip into the tailpipe. You may encounter some resistance, so, if necessary, use automotive grease to lubricate the pieces. Cover the end of the exhaust tip with a towel and tap it into a place with a rubber mallet. Step 3: Fasten/weld the exhaust tip. Tighten screws and clamps to secure the exhaust tips. Should you worry that it is not tight enough, you can weld a joint between the edges of the tailpipe and the exhaust tip. Then, the installation is complete. Protect the Original Tailpipe: Protect the original exhaust pipe from sun and rain to prevent rusting and deformation. Nice Looking: The black painting finish, elegant and mysterious, perfectly decorates the tailpipe of your car. Specification: Inlet Size: 3.5 Inch Inside Diameter Length: 12.0 Inch Overall Length Material: Black Paint Finish Stainless Steel Package: 1 piece exhaust tip Note: Please measure the size of your exhaust pipe prior to purchase of this exhaust tip.