AuInn Laminate Wood Flooring Installation Kit with Tapping Block Pull Bar Mallet and 30 Spacers

Size ? Double Headed Mallet : Approx. 25x7.85 cm/ 9.84x3.09 inch(WxL) ? Pull Bar : Approx. 26.2x4.78 cm/ 10.31x1.88 inch(WxL) ? Tapping Block : Approx. 16x6.5 cm/ 6.30x2.56 inch(WxL) ? Spacer : Approx. 5.92x2.96 cm/ 2.33x1.16 inch(WxL) Double Headed Mallet Features ? Knock resistance, oil resistance, skid resistance. ? The handle is specially embedded in the hammer head, which is not easy to fall off. ? The hammer head is made of high quality cream rubber, wear-resistant, good elasticity. Will not destroy the surface and effectively protect the object being knocked. ? Quality steel hammer bar, high frequency quenching forging, high strength, wear resistance, long service life. Applications ? Suitable for 0.27in (7mm) - 0.6in (15mm) laminate/hardwood flooring. ? This Laminate Flooring Kit could be used to strengthen the floor as well as installing solid wood composite floor. ? For both domestic and professional use. Applied Occasions ? Pull Bar : To eliminate gaps on the long side of the planks. ? Tapping Block : Could be inserted into the tongue of the plank when tapping two planks together. ? Spacers : Adjust the thickness of the gap. (Note : Make sure to place the spacers on the edges, leaving enough room for expansion if needed.) ? Using the mallet to hammer the tapping block could help eliminate gaps between planks. Package Contents ? 1 x Double Headed Mallet ? 1 x Pull Bar ? 1 x Tapping Block ? 30 x Spacers Note ? Manual measurement, error 1-3mm, depending on the actual situation, please understand. ? Please check the size before purchasing.