AOMAG Pneumatic 3 8 PT 5 Way 2 Postion Air Hand Lever Operated Valve Pneumatic Solenoid Valve Manual Control Push Pull 4H310 10

Only 25psi Can Start the Solenoid Valve, Which is Easy to Operate, Easy to Install and Easy to Remove.The Valve Body is Made of High Precision Aluminum with High Hardness and Long Service Life. Air Inlet Port with 0.04mm Filter Screen, Can Filter Most Impurities and Dust, Keep the Valve Body Clean, Prolong Service Life The Valve Body Contains a High Concentricity Seal Ring, Which is Not Easy to Leak, and the Rubber Pad with Lubricating Oil Reduces Friction. Each Product Comes with Fittings That Can Be Used Directly. No Need to Buy Additional Accessories, Just Insert 6mm or 1/4"tube. Driven Automatically by Compressed Air. with Hand Lever, Can Be Controlled Manually to Deal with Some Special Situations. Widely Used to Control the Flow of Various Types of Fluids Such As Air, Water, Mud, Liquid Metals, Etc. The Five-port Two-position Manual Reset Type Manual Valve Adopts Spring Steel Ball Positioning, Which is Responsive and Easy to Switch. Please Pay Attention to Excessive Force and Control Position Error Caused by Mistake. Notes: Please Check Whether the Products and Accessories Are Damaged or Lost Before Using Them. Pay Attention to Whether the Air Flow Direction is Correct During Installation (as Shown in Page A+). Incorrect Air Flow Direction Will Cause the Solenoid Valve to Be Unable to Be Used Normally. Please Pay Attention to Whether the Service Environment Meets the Requirements of the Product (such As Air Pressure Range, Temperature Range, Voltage, Etc.). Please Do Not Use the Product in the Environment of Shaking or Vibration, Please Pay Attention to the Response of the Solenoid Valve at Low Temperature. Before Installation, Please Check the Threaded Mouth for Impurities. After Cleaning, Wrap the Teflon Tape Around the Fittings for 3-5 Rings. Teflon Tape Should Not Block the Air Mouth Under the Fittings.