10Ft AN6 Stainless Steel Braided Oil Fuel Hose Line+ 8PCS AN6 Hose End Fitting Adapters Kit
How to get a good connection of the hose and fittings?
1?Disassemble the fitting first and slide the sleeve over the end of the braided hose
2?With the hose end fully seated in the sleeve,Push the other side of the fitting into the hose and sleeve while turning to make sure the threads insert the hose
3?Using the Aluminum AN adjustable wrench to protect the finish,continue screwing the fitting together until it is completely assembled
An adjustable AN wrench is highly recommended
A quick and easy tip for cut hose without destroying the steel braid:
Wrap duct tape tightly at the cut off area and cut through the center of the wrapped up tape rotating the hose during the cut!! before you unwrap the 1/2 tape use a belt sander or Belt grinder (hard wheel bench grinder may work too) to deburr the edge of the hose grinding it away from the hose itself
Item Specifications:
Application:Universal (for most transmission oil/fuel/water)
Fitting Material:Aluminum Alloy
Fitting size:AN6
Working pressure: 1000PSI
Burst Pressure: 6000 PSI
Hose Inner Diameter: 8.73mm(0.34inch)
Hose Outer Diameter: 14.22mm(0.56inch)
Working temperature:-40F to +257F degrees
Length: 10Ft / 3M
Note:
- Professional installation is highly recommended
Package Included:
1 * AN-6 Stainless Steel Braided Hose (10Ft / 3M)
2 * AN-6 Straight Reusable Swivel Hose End
2 * AN-6 45 Degree Reusable Swivel Hose End
2 * AN-6 90 Degree Reusable Swivel Hose End
2 * 10AN to 6AN Hose Reducer