Alchemy Power Inc. Pi-EzConnect. Raspberry Pi 2 and Raspberry Pi 3 GPIO connector. A HAT to connect GPIOs and sensors to Raspberry a Pi-2 or Pi-3.

Before Pi-EzConnect, a flat ribbon cable, a breadboard and other wires are being used to connect the temperature sensor to the Raspberry Pi. With the Pi-EzConnect, the connection is simplified as shown. Watch the video on You Tube - https://youtu.be/oChXSE0etQw Power bus - both 3.3V as well as the 5V power bus is available on Pi-EzConnect. Ground bus is also available on Pi-EzConnect. Electronic devices such as pull up or pull down resistors, LEDs, other components can easily be soldered onto the solder points on the Pi-EzConnect. Sensors can also be soldered on solder points provided. Alternately, use the solderless connectors provided. Extended header pins allow other HATs to be connected to Pi-EzConnect without any loss of functionality. To mount the Pi-EzConnect board on the Raspberry Pi use the 2.5mm x 15mm brass spacer standoff kit for Raspberry Pi HATs / boards available from Amazon (Amazon URL https://www.amazon.com/dp/B01M71WKMS - copy and paste the URL in your browser if you cant find the kit). These spacers provide stability to the board and the Raspberry Pi. Data sheet and other relevant information on Alchemy Power web site. Pi-EzConnect works with 40 pin headers conforming to Raspberry Pi 40 pin definition. This includes variants as Pi-2, Pi-3, Asus Tinker board, Orange etc.