4G0-13586-02, Carburetor Intake Manifold Boot for Yamaha Seca 550 XJ550R Maxim 550 XJ550 1981-1983, 4G0-13596-02

? Part Number: JC02016 4G0-13596-02 4G0-13586-02 ? Fitment: For 1981-1983 Yamaha Seca 550 XJ550R For 1981-1983 Yamaha Maxim 550 XJ550 ? Function: Carburetor Intake Manifold Boot give your machine the new power and torque it really deserves which would make your drive more stable than ever. Replacing the new intake manifold interface will solve problems such as high idle speed, low acceleration, and easy flameout during acceleration. ? Colour: Black ? Composition: metal + rubber ? Category: Carburetor Intake Manifold Boot ? Features: It has a good thermal aging stability, chemical stability, and dimensional stability. Its high temperature resistance and strength would make sure the safety of the carburetor is guaranteed ? Installation: 1. To install the intake pipe, you need to remove the carburetor, loosen the fixing screws of the air filter, and move the air filter to the rear. 2. Then it is easier to remove the carburetor 3. Finally, remove the intake pipe. 4. If it is Euro 2 type, the intake pipe screw may need to be removed with an impact screwdriver. 5. There should be a rubber O-ring in the aluminum groove behind the intake pipe, which can be taken off the new one. 6. Do not start immediately after installation, wait until the oil in the oil pipe enters the carburetor and start again. ? Service: 2 year shelf life If you have any problems with your products, please reply to us by email in time. ? Package: 4x Carburetor Intake Manifold Boot 4x Gasket (without hose clamps)