This helps to prevent the heat from the nozzle traveling too far upwards. Without this fan, the filament could get soft above the heater block, which leads to extrusion issues and degradation of print quality. This is a DC 12V 0.08A cooling fan. Dimensions are 40mm x 40mm x 10 mm. Sufficient for use in 3D printing, operating speed is 6000 RPM. Equipped to properly cool your 3D printer's extruder assembly, this extruder fan is compatible with the MakerBot Replicator 2 and MakerBot Replicator 2X. Also compatible with Flashforge, CTC, and other 3D printer types.
Specification:
Rated Voltage: DC 12V
Consuming Current: 0.08A
Connector: 2pin-ph2.5
Speed: 6000 + -10% RPM
Air Flow: 6.5 CFM
Static Pressure: 2.9
Noise Level: 27dBA
Note: Any questions, you can contact us and we will give you a satisfied solution!
Notice!!!Please check the fan plug, maybe the plug was wired opposite of the fan it was replacing, that is reverse polarity.