4 Foot T8 LED Tube Lights, F32/T8 Fluorescent Tube Replacement, Daylight White, UL Approved, Pack of 4 (17 Watt, 3500K)

LED tube light you don't have to worry about flickering CFL tube light or glass breakage no mercury or hazardous materials. To install Take out ballast and starter if so equipped (disconnect the wires and either leave the ballast in place or remove it). After disconnecting the ballast, reconnect the circuit. There are two sets of wires that connect to each bulb - only one set is needed to be connected to the respective hot and cold wires. Refer to the wiring diagram in image 2. If you have a fixture with more than one tube holder (double or quads), make sure only one wire set from each additional fixture is going to the hot and cold supply wires. Disconnect any jumper wires connecting the additional fixtures to each other. In effect, on a single tube there were four wires (two at each end) going to the hot and cold supply wires. Now you only need one going to the hot and cold supply wires from each fixture. Refer to the wiring diagram in image 2. Install the new LED Tube into the fluorescent light fixture. Inspect all wiring connections prior to turning on the power. Switch on the power to light the LED tube.