(30Pcs) Swage Threaded Stud Tension End Fitting Terminal for 1/8 Cable Deck Railing Hand Swage,Stair,Deck, Railing; Wood & Metal Post Balusters T316 Stainless Steel (1/8")

Integrated design, entire body made of T316 stainless steel?Use hydraulic pliers to assist installation,After the installation is completed, the overall effect is simple, beautiful and generous.Can bring you a lot of praise. Package Included: 30 x Railing Cable Tensioners?30 acon nuts ?30 hex nuts?30 washers? Free gift is to be able to better feed you service, if you are satisfied, is my honor, if not satisfied, please be tolerant, I will continue to improve the service. If you have any questions, please contact us immediately. Thank you. INSTALLATION INSTRUCTIONS: When you get this set of products, please check that the wire rope[please search for "B07C4TF6J6 " and 'B07H1XNJLW ' click to find them and buy it ], scissors, hydraulic pliers, sharpened pencils and tape measure are ready. 1.Firstly ,we need to divide the height of post into equal distance and mark with a pencil. 2.Then drill a though-hole with a 1/4 inch drill bit? 3.Put the wire rope into swage end and crimp it with a hydraulic crimper. 4.Crimp twice to make sure it is firm enough,so that the cable won't loose. 5.After that you can install this one on post. 6.Then we start the other side with pretty much the same steps ,dill hole ,measure the length before marking the position. 7.Since the adjustable range of this ,terminal is not very wide ,it is important to reserve less extra length ,on wire rope .cut the cable with cable cutter.as you can see the cutting profile is clean without fraying or smashing. 8.Install another terminal and tighten the nut to tense the cable ,put the cap on ,then it is done. Ok ,enjoy diy,enjoy life.