2pcs E_Simpo 5W G23 LED Bulb 2_Pin LED PL Retrofit Lamp CFL 9W 13w Replacement 180 View Angle LED PL Horizontal Recessed Down Light Bulb_Need Bypass Ballast_ _Cold White_ G23 5W_

2pcs E-Simpo 5W G23 LED Bulb 2-Pin LED PL Retrofit Lamp CFL 9W 13w Replacement 180° View Angle LED PL Horizontal Recessed Down Light Bulb(Need Bypass Ballast) (Cold White, G23 5W) Specification Input Voltage: 85-300V AC Power: 5W NO Dimmable CRI>82 LED: SMD2835 Base: G23, Gx23 Optional. Please distiguish the base carefully before you buy. G23 has only one locking tab, GX23 has double locking tab. Both are 2Pin in Parallel. Brightness: 5W: 450-550Lumens; Color Temperature: Warm White 3000-3500K; Cold White 6000-6500K Please check the PL Lamp fixture or table light fixture for allowed install length before you decide. Size: 3W: L107mm*D27mm/ L4.2"*D1.0" 4W: L135*D27mm/L5.3"*D1.0" Application: 5W is used to Replace 2-Pin CFL PL-S 7W 13w Note: 1. Please check if the inside ballast is inductive ballast or electronic ballast; 2. If it is inductive ballast, you can use this LED lamp directly, just plug and play. 3. If it is electronic ballast, the led driver can not work compatibly with the electronic ballast, so you have to bypass the electronic ballast. Otherwise the LED Lamp witll get flicking, burnt, smell, damaged. How to bypass the ballast? 1. Turn Off the Power. 2. Find the Ballast. Usually it is embeded inside the ceiling fixture. Pls pull off the existing PL lamp, reflector. Leave wire in junction box. and find the ballast. 3. Normally, the Ballast has a black and white wire on the input side (AC input side, 100V -120V for North America). It also has two red and two blue output wires. To bypass this ballast, please cut all the Input and output wires, so total 6 wires cut. 4. Then, you can connect the two red wires to the black wire. 5. Next, connect the two blue wires to the white wire. now ballast is bypassed.