2pcs E-Simpo G23 5W LED Bulb PL-9W pl-13w Bulb led Replacement G23d 2P LED PL Retrofit Horizontal Recessed Down Light Plug Play for INDUCTANCE Magnetic Ballast Cold White 6.5inch 165mm 5W

165mm/6.5" G23 LED Bulb 5W/CFL PLS-9W 13W Replacement 2-Pack E-Simpo G23d 2P LED PL Retrofit Horizontal Recessed Down Light Plug Play for Inductance ballast, Rewire required for ELECTRONIC Ballast. Specification Input Voltage: 85-300V AC Power: 5W LED, Can replace CFL 9W 13W PL Lamp Dimmable CRI>82 Base: G23d-2. NOT Gx23 Brightness: 5W: 450-550Lumens; Color Temperature: Warm White 3000-3500K; Cold White 6000-6500K Please check the PL Lamp fixture or table light fixture for allowed install length before you decide. 165mm long 6.5" Application: 5W is used to Replace 2-Pin CFL PL-S 9W 13w. Great Gx23 led replacement lamp for OttLite fluorescent table lamp, and replace Osram 13w,clean bright non flickering light, it turned it on instantly, no buzzing noise. Note: 1. Please check if the inside ballast is inductive ballast or electronic ballast; 2. If it is inductive ballast, you can use this LED lamp directly, just plug and play. 3. If it is electronic ballast, the led driver can not work compatibly with the electronic ballast, so you have to bypass the electronic ballast(cut off the transformer). Otherwise the LED Lamp witll get flicking, burnt, smell, damaged. How to bypass the ballast? 1. Turn Off the Power. 2. Find the Ballast. Usually it is embeded inside the ceiling fixture. Pls pull off the existing PL lamp, reflector. Leave wire in junction box. and find the ballast. 3. Normally, the Ballast has a black and white wire on the input side (AC input side, 100V -120V for North America). It also has two red and two blue output wires. To bypass this ballast, please cut all the Input and output wires, so total 6 wires cut. 4. Then, you can connect the two red wires to the black wire. 5. Next, connect the two blue wires to the white wire. now ballast is bypassed.