235 X 235mm Ender 3 Pro Double sided Textured PEI Spring Steel Sheet Powder Coated PEI Build Plate for Creality Ender 3 Ender 4 Ender 5 Ender 3S and TEVO Tarantula Pro 3D Printer

Advantages: No more 3M Masking tape No more glue stick No more ABS juice No more PEI sheet replacement Easy to print Easy to remove by bending and popping it off Easy to maintain Double-sided Lower runing cost especially for printing farm Genuine PEI powder coating Hardened steel spring sheet never diforming Possible to adding ABL for some low-cost printers *Make adding inductive Z-probe possible Maintenance: Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE, and RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed. ????Attention: *It is possible to mount our kits on a larger bed, just be aware that you will have a reduced printing area. It is also possible to mount our kits on slightly smaller beds; you can carefully trim the Magnetic Base, but the Flexi Plate will stick over your edges, be sure that there are no obstructions such as vertical frame elements, and it is advisable not to have more than 10mms overhang per side to avoid warping. we are not responsible for mistaken order sizes.